Microsoft Microsoft Partner Competency exam 74-134 Web Demo
This webdemo is just a demo data, only for reference and learning, there is no other purposes.
1. You are a system builder.
Your network uses a Microsoft Windows Server? 2003 that is running the
Dynamic Host Configuration Protocol (DHCP) service and is set up as a
technician computer.
You installed OPKTools from Microsoft Windows? XP Service Pack 2. You
run Setup Manager and create a configuration set to install a Microsoft
Windows operating system.
You edit the winbom.ini file in the configuration set and copy the
winbom.ini file to a floppy disk. You boot the master computer by using
your Microsoft Windows Preinstallation Environment CD, and you insert
the floppy disk with the winbom.ini file.
You get the following error message: Cannot Authenticate to the Server.
What should you do? (Each correct answer presents a complete solution. Choose two.)
A. Verify that the passwords used for connecting are the same in the configuration set and on the floppy disk.
B. Verify that the Gateway= parameter is included in the winbom.ini answer file.
C. Verify that the StartNet=yes parameter is included in the unattend.txt answer file.
D. Verify that the network interface card in the master computer is plugged in to the crossover cable.
Answer: AB
2.You
run Setup Manager and create a configuration set to install a Microsoft
Windows operating system.
You edit the winbom.ini file in the configuration set and copy the
winbom.ini file to a floppy disk. You boot the master computer by using
your Microsoft Windows Preinstallation Environment CD, and you insert
the floppy disk with the winbom.ini file.
You get the following error message: Cannot Authenticate to the Server.
What should you do? (Each correct answer presents a complete solution. Choose two.)
A. Verify that the passwords used for connecting are the same in the configuration set and on the floppy disk.
B. Verify that the Gateway= parameter is included in the winbom.ini answer file.
C. Verify that the StartNet=yes parameter is included in the unattend.txt answer file.
D. Verify that the network interface card in the master computer is plugged in to the crossover cable.
Answer: AB
2. You are a system builder.
Your network is using a four-port router that is running the Dynamic
Host Configuration Protocol (DHCP) service. Your technician computer
runs Microsoft Windows? 2000 Professional and is connected to the
four-port router.
You have installed a media reader card in a computer, and you use
OPKTools to preinstall this computer over the network. In Audit mode
you discover that the media card reader device has failed and that it
is not enumerated in Device Manager.
You need to preinstall your computers with this card reader.
What should you do? (Each correct answer presents part of the solution. Choose two.)
A. Add the DriverSigningPolicy=Ignore parameter in the Unattended
section of the unattend.txt answer file to preinstall the unsigned
driver.
B. Remove the incorrect driver that was installed.
C. Add the DriverSigningPolicy=Warn parameter in the Unattended section of the unattend.txt answer file.
D. Obtain an updated driver (if one exists) from the manufacturer.
E. Run sigverif.exe from a command prompt to verify that all the drivers are signed.
F. Add the DriverSigningPolicy=Block parameter in the Unattended section of the unattend.txt answer file.
Answer: AD
3. You are a system builder.
Your network uses a Microsoft Windows Server? 2003 computer that is
running the Dynamic Host Configuration Protocol (DHCP) service.
You create a configuration set for a Microsoft Windows Small Business
Server 2003 installation and preinstall a computer for your customer.
You create the directory Sysprep and copy all the necessary files into
this folder. You then run sysprep on the computer by using the
following command: C:SysprepSysprep.exe -dc ?????>